TheDayAfterYesterday
Apprentice Member
When the game ends, the pawn and the king go into the same box
Posts: 118
|
Post by TheDayAfterYesterday on Jul 4, 2015 22:06:06 GMT -6
When it comes to editing an audio track for an animation/video/song/etc..., what equipment and/or settings do you use to determine when it is loud, quiet, or moderate?For example when I'm sound editing I usually wear a headset and have my laptop volume set to 25%. Setting the volume at 25% without a headset, the audio would probably be too loud or too quiet since the surface the laptop is set on becomes a factor and the surrounding environment is more audible. Based on that, when I'm trying to create balance between voices, ambience, music, etc it is solely based on the 25%. When it comes to differentiating between loud, quiet, and moderate I usually play it by ear. If I were more knowledgeable about this subject I'd probably talk in terms of decibels(dB) and things of that nature, but I'm not going to pretend I am. Which brings up another question... What do you set your computer volume to when your listening to an animation/video/song/etc...?I usually have my volume set between 30% - 60%. When it comes to fanime, I feel like they're aiming towards 105 decibels if not higher as a precaution they get their own volume presets. 25% - 35% for the loud ones 55% - 75% for the quiet ones {Decibel Chart}
|
|
|
Post by letzshake on Jul 4, 2015 23:36:23 GMT -6
I usually set my laptop volume to 30-35% when I'm listening to stuff with my "good" headphones. I use my earbuds just as frequently though, if not more, and they seem quieter, so for them I bump it to like 50%. My built-in speakers are reasonably loud at 50%.
If I was editing audio, I'd probably just play it by ear and do my best. When I play games I like to set the levels as 100% for voice, ~90% for music and maybe 85% for sound effects, so I'd probably use that as a general rule of thumb. Then I'd check how it sounds on both my different headphones and maybe my speakers! That's good enough for me.
On the rare occasions when I'm making music, I only really mess with the volume when I hear something clipping. Everything's probably pretty consistent until I start giving small boosts/cuts when mixing, but I think that has more to do with frequencies than amplitude.
|
|
|
Post by Phoenix on Jul 5, 2015 2:03:50 GMT -6
Though it can vary widely, I tend to keep the sound card's volume maxed for most applications. For the actual speakers and synthesizers I adjust the volumes to levels that prevent clipping while still allowing the full range of sounds to be fully audible.
And just because everything is set to 16/24/32bit 192khz.
One last note is that reference level audio is about 75db
|
|